Configuring The Callpilot 100/150 Initial Parameters - Nortel CallPilot 150 Installation And Maintenance Manual

3 Press NEXT to show the next Feature Code used by CallPilot . Record this code in
on the CallPilot Programming Record or the Call Center Programming Record.
4 Repeat step 3 until you reach the final Feature Code.
5 Press QUIT to end this session.

Configuring the CallPilot 100/150 initial parameters

To configure the CallPilot 100/150 initial parameters:
Pswd:
RETRY OK
App:voicemail
CHNG NEXT
Bilingual?
YES NO
1. Press ≤·°‹ .
This is the default System Administration feature code. If
your system does not use the default feature codes, enter
the System Administration feature code you determined
earlier.
2. Enter ¤flfl‹›› (CONFIG) and press OK .
3. Press CHNG to toggle the settings between voicemail or
CallCenter .
If you choose voicemail :
• the voicemail application is enabled
• 20 mailboxes are enabled on CallPilot 150
• 10 mailboxes are enabled on CallPilot 100
If you choose CallCenter :
• the Call Center application is enabled
• 20 agents are enabled (10 agents are active)
• no mailboxes are enabled
4. Press NEXT .
5. Press Y if you want the display and voice prompts to be avail-
able in two languages.
Press N if you want the display and voice prompts to be avail-
able in one language.
When you choose N (No) for the Bilingual option, step 6 is not
required and the system automatically goes to step 7.
CallPilot 100/150 Installation and Maintenance Guide
Chapter 5 Initializing the CallPilot 100/150 39
Table 9 and