Running The Quick Install Wizard; Table 8 Quick Install Wizard Parameters For A Callpilot 100/150 - Nortel CallPilot 150 Installation And Maintenance Manual

Running the Quick Install Wizard

The Quick Install Wizard appears the first time you startup CallPilot Manager. The Quick Install
Wizard is a single page that gathers enough information to set up a working system. It then applies
the information and restarts the system.
You can reach CallPilot Manager from another computer through a LAN connection, WAN/
Internet connection or an Ethernet crossover cable. All of these methods create an IP connection
that allows you to run CallPilot Manager.
Use the following procedure to run the Quick Install Wizard:
1 Launch your browser.
2 In the URL address box, type the CallPilot 100/150 IP address.
For example: HTTP://192.168.110.10
Note: You must include HTTP:// to access CallPilot Manager.
The Quick Install Wizard screen appears. Depending on your system, this can take several
minutes to appear.
3
Configure the Quick Install parameters for a CallPilot 100/150 according to
35.

Table 8 Quick Install Wizard parameters for a CallPilot 100/150

Field name
IP Address
Subnet Mask
Primary DNS
Secondary DNS
Description
Enter the IP Address for the CallPilot 100/150. If you do not know the IP Address,
contact your network administrator.
This is the IP Address you will use to access the CallPilot 100/150 using CallPilot
Manager.
Changes to the IP Address take effect when you reboot the CallPilot 100/150.
If this is a re-install, the IP Address shows the current settings, not the factory default.
Enter the Subnet Mask for the CallPilot 100/150. If you do not know the Subnet Mask,
contact your network administrator.
Changes to the Subnet Mask take effect when you reboot the CallPilot 100/150.
If this is a re-install, the Subnet Mask shows the current settings, not the factory default.
Enter the IP Address of the Primary DNS server that CallPilot 100/150 uses. If you do
not know the IP Address, contact your network administrator.
The Primary DNS server allows you to use domain names, such as
www.nortelnetworks.com, instead of IP addresses when accessing a site.
Note: If you do not use DNS, leave this box blank. CallPilot applications, such as Digital
Networking, can use a DNS server even if you leave this box blank.
Enter the IP Address of the Secondary DNS server that CallPilot 100/150 uses. If you
do not know the IP Address, contact your network administrator.
CallPilot 100/150 uses the Secondary DNS server if it cannot contact the Primary DNS
server or if the domain name is not listed in the Primary DNS server.
Note: If you do not use DNS, leave this box blank. CallPilot applications, such as Digital
Networking, can use a DNS server even if you leave this box blank.
Chapter 5 Initializing the CallPilot 100/150
CallPilot 100/150 Installation and Maintenance Guide
35
Table 8 on page