Maximum Rtp Port Number; Telephone-Event Payload Type - Panasonic KX-UT670 Administrator's Manual

Value Range
Default Value
Configuration File Reference

Maximum RTP Port Number

Description
Value Range
Default Value
Configuration File Reference

Telephone-event Payload Type

Description
Value Range
Default Value
Configuration File Reference
Document Version 2012-07
1024–48750 (even number only)
Note
•
The value for this setting must be less than or equal to
"[Maximum RTP Port Number] - 400".
•
Changing this setting may affect the number of simultaneous
calls that can be made. Therefore, when setting this parameter,
be aware that the maximum number of necessary ports can be
calculated as shown below:
No. of lines ´ No. of channels ´ 2 ´ 10 (No. of terminals)
16000
RTP_PORT_MIN (Page 180)
Specifies the highest port number that the unit will use for RTP packets.
Note
•
If port numbers are specified in [Channel 1–25] in
4.4.5.3 External RTP Port, this setting is ignored and the
corresponding external RTP port is enabled.
1424–49150 (even number only)
Note
•
The value for this setting must be greater than or equal to
"[Minimum RTP Port Number] + 400".
•
Changing this setting may affect the number of simultaneous
calls that can be made. Therefore, when setting this parameter,
be aware that the maximum number of necessary ports can be
calculated as shown below:
No. of lines ´ No. of channels ´ 2 ´ 10 (No. of terminals)
20000
RTP_PORT_MAX (Page 180)
Specifies the RFC 2833 payload type for DTMF tones.
Note
•
This setting is available only when [DTMF Type] is set to
[Outband].
96–127
101
TELEVENT_PAYLOAD (Page 183)
Section 4 Web User Interface Programming
Administrator Guide 99