Section 1 Initial Setup
Note
•
For details about the administrator password, see 3.1.2 Phone User Interface Administrator
Menu.
•
When both [Use LLDP] and [Use VLAN] are checked, VLAN settings are prioritized.
Date and Time (NTP Server) Settings
The following procedure explains how to set the date and time using a NTP (Network Time Protocol) server
via the unit.
1.
Press
2.
Tap [Date & time] and then select [NTP Server].
3.
Check [Use NTP server].
4.
Enter the NTP server's address.
5.
Enter the synchronization interval.
6.
Tap [OK].
Note
•
If your phone system dealer does not allow you these settings, you cannot change them even though
the unit shows the setting menu. Contact your phone system dealer for further information.
1.1.4 Other Network Settings
1.1.4.1 Firewall and Router Setup
When the unit is connected to a network that is protected by a firewall and/or router, you need to configure the
firewall and/or router so that they do not block communication from the IP address and port number used by
the unit.
18
Administrator Guide
on the Home screen, and then tap [Settings].
Document Version 2012-07