Install The Faceplate Insulation - FireplaceXtrordinair Xtrordinair 44 Elite Installation Manual

28 Finalizing the Installation

Install the Faceplate Insulation

Attach the faceplate insulation (included with the fireplace) to the back of the face (see the
illustrations below).
Peel the backing off the double-backed tape on the top
(arched) piece of gasket. Make sure to leave the tape
attached to the gasket (use a knife if necessary).
Attach the side gaskets in the same fashion, making sure
the holes in the gasket line up with the holes on the face.
Attach the lower gasket in the
same fashion, making sure the
holes in the gasket line up with
the holes on the face.
© Travis Industries
(for qualified installers only)
Attach the gasket onto the back of the face (note how the holes
on the gasket line up with the holes on the face). The 36 is
pictured – the 44 installs in a similar fashion.
4050714
On the 36 you will need to trim the excess
gasket on the upper corners (the 44 does not
require trimming).
On the 36 you will
need to trim the
excess gasket on the
lower corners (the 44
does not require
trimming).
93508093