Switchplate Installation And Blower Check - FireplaceXtrordinair Xtrordinair 44 Elite Installation Manual

30 Finalizing the Installation

Switchplate Installation and Blower Check

•
Attach the two male quick-connects from the switch plate to the two female quick-connects
leading from the fireplace (see Figure 35). If the optional summer fan switch is being used,
connect the other two quick connects, otherwise tuck the two male quick-connects leading from
the fireplace into the cavity behind the faceplate. Attach the switch plate to the faceplate
using a standard screwdriver (NOTE: the attachment screws are threaded into the faceplate).
Lower Right
of Faceplate
These male quick-connects are
for the summer fan switch
(connect them together to test
if the blower operates).
•
Test the blower circuit by following the directions in Figure 36.
a
© Travis Industries
When installing the
switch plate, tuck the
rheostat behind the
bracket.
Depress the
Remove the right
door switch.
forward side brick.
(for qualified installers only)
Attach the two male quick-connects from the
switch plate to the two female quick-
connects leading from the fireplace.
Use a propane torch or
b
c
other heat source to heat
the area at the center of
this plate. The blower, if
connected properly,
should start within 30 to 60
seconds.
4050714
Use a standard
screwdriver to attach
the switch plate
Figure 35
Figure 36
93508093