Replace The Console Or Auxiliary Cable; Figure 45: Ethernet Cable Connector - Juniper M10 Hardware Manual

such cable is provided with the router. For cable specifications, see "Cable Specifications for
Routing Engine Management Interfaces" on page 52. Follow this procedure:
1.
2.
3.

Figure 45: Ethernet Cable Connector

Replace the Console or Auxiliary Cable

To use a system console to configure and manage the Routing Engine, connect it to the
appropriate CONSOLE port on the craft interface. To use a laptop, modem, or other auxiliary
device, connect it to the appropriate AUX/MODEM port on the craft interface. Both ports
accept an RS-232 (EIA-232) serial cable with DB-9/DB-9 connectors. One such cable is
provided with the router. If you want to connect a device to both ports, you must supply
another cable. For cable specifications, see "Cable Specifications for Routing Engine
Management Interfaces" on page 52.
To connect a management console or auxiliary device, follow this procedure:
If a cable is already installed in the MGMT port for the relevant Routing Engine,
perform the following steps:
a. Press the tab on the connector and pull the connector straight out of the port.
Figure 45 shows the connector.
b. Disconnect the cable from the network device.
Plug one end of the replacement Ethernet cable into the appropriate MGMT port. Figure
44 shows the external device ports on the craft interface.
Plug the other end of the cable into the network device.
Replace Routing Engine Components
Replace Hardware Components
119