Rj-48 Cable Pinouts For E1 And T1 Pics; Table 20: Db-9 Connector Pinout; Table 21: Rj-48 Connector To Rj-48 Connector (Straight) Pinout - Juniper M10 Hardware Manual

RJ-48 Cable Pinouts for E1 and T1 PICs

to a laptop, modem, or other auxiliary unit, and the CONSOLE port connects it to a
management console. The ports are configured as data terminal equipment (DTE). For more
information, see "Routing Engine Interface Ports and Status Indicators" on page 15. Table
20 describes the DB-9 connector pinouts.

Table 20: DB-9 Connector Pinout

RJ-48 Cable Pinouts for E1 and T1 PICs
The E1 and T1 PICs use an RJ-48 cable, which is not supplied with the PIC.
Table 21, Table 22, Table 23, and Table 24 describe the RJ-48 connector pinouts.

Table 21: RJ-48 Connector to RJ-48 Connector (Straight) Pinout

172
M5 and M10 Internet Routers Hardware Guide
Pin Signal
1 DCD
2 RxD
3 TxD
4 DTR
5
Ground
6 DSR
7 RTS
8 CTS
9 RING
To maintain agency approvals, use only a properly constructed, shielded
cable.
RJ-48 Pin
RJ-48 Pin (on T1/E1 PIC) (Data numbering
(Data numbering form) form)
1 1
2 2
4 4
5 5
Direction Description
<–
Carrier Detect
<–
Receive Data
–>
Transmit Data
–>
Data Terminal Ready
—
Signal Ground
<–
Data Set Ready
–>
Request To Send
<–
Clear To Send
<–
Ring Indicator
Signal
RX, Ring, –
RX, Tip, +
TX, Ring, –
TX, Tip, +