Table 17: Chassis Alarm Messages; Table 18: Sonet/Sdh Interface Alarm Messages - Juniper M10 Hardware Manual

Table 17: Chassis Alarm Messages

Table 18: SONET/SDH Interface Alarm Messages

Component CLI Message
Craft interface Craft interface not responding
Fans fan-name removed
fan-name stopped spinning
Too few fans installed or working
PICs Too many recoverable errors
Too many unrecoverable errors
Power supplies Power supply x not providing power
Power supply x 2.5V failed
Power supply x 3.3V failed
Power supply x 5V failed
Temperature temperature-sensor temperature sensor failed
sensors
A temperature sensor exceeds 54 degrees C
CLI Message
interface-name so-x/x/x - SONET bit error rate defect
interface-name so-x/x/x - SONET bit error rate fault
interface-name so-x/x/x - SONET line AIS
interface-name so-x/x/x - SONET line remote defect indicator
interface-name so-x/x/x - SONET loss of frame
interface-name so-x/x/x - SONET loss of light
interface-name so-x/x/x - SONET loss of pointer
interface-name so-x/x/x - SONET loss of signal
interface-name so-x/x/x - SONET path AIS
interface-name so-x/x/x - SONET path mismatch
interface-name so-x/x/x - SONET path remote defect indicator
interface-name so-x/x/x - SONET PLL lock
interface-name so-x/x/x - SONET remote error indicator
interface-name so-x/x/x - SONET severely errored frame
interface-name so-x/x/x - SONET unequipped
Overview of Troubleshooting Resources
Troubleshoot Hardware Components
123