Diagnosis And Testing - Vehicle Theft Security System; Decklid Security Switch Removal; Installation; Vehicle Theft Security - Chrysler 300M Service Manual

LH
VEHICLE THEFT SECURITY (Continued)
(2) Disconnect and isolate the battery negative
remote cable from the remote terminal. Unplug the
wire harness connector at the SKIM. Check for con-
tinuity between the ground circuit cavity of the
SKIM wire harness connector and a good ground.
There should be continuity. If OK, go to Step 3. If not
OK, repair the open circuit to ground as required.
(3) Connect the battery negative remote cable.
Check for battery voltage at the fused B(+) circuit
cavity of the SKIM wire harness connector. If OK, go
to Step 4. If not OK, repair the open circuit to the
fuse in the junction block as required.
(4) Turn the ignition switch to the ON position.
Check for battery voltage at the fused ignition switch
output (run/start) circuit cavity of the SKIM wire
harness connector. If OK, use a DRB III scan tool
and the proper Body Diagnostic Procedures Manual
to complete the diagnosis of the SKIS. If not OK,
repair the open circuit to the fuse in the junction
block as required.
DIAGNOSIS AND TESTING - VEHICLE THEFT
SECURITY SYSTEM
Using a DRB III scan tool and the proper Body
Diagnostic Procedures manual, each switch input can
be checked using this method.
For complaints about the Theft Alarm going off on
it's own, use the DRB III scan tool and select "Theft
Alarm", "VTSS" then "Monitor Display" and read the
"Alarm Tripped By" status.
DECKLID SECURITY SWITCH
REMOVAL
(1) Open hood, disconnect and isolate the negative
battery cable remote terminal from the remote bat-
tery post.
(2) Refer to Body, Deck Lid, Deck Lid Latch
Removal.
(3) Disconnect connector and remove deck lid lock
cylinder from bracket (Fig. 2), (Fig. 3), and (Fig. 4).

INSTALLATION

(1) Connect connector and install the deck lid lock
cylinder onto bracket (Fig. 2), (Fig. 3), and (Fig. 4).
(2) Refer to Body, Deck Lid, Deck Lid Latch,
Installation.
VEHICLE THEFT SECURITY 8Q - 3
Fig. 2 DECK LID LATCH - CONCORDE/LHS
1 - TRUNK LID
2 - TRUNK LID CYLINDER BRACKET
3 - TRUNK LID LATCH
4 - LOCK SET
5 - TRUCK LID LOCK CYLINDER
6 - TRUNK LID OVER SLAM BUMPERS
Fig. 3 DECK LID LATCH - INTREPID
1 - LOCK CYLINDER BRACKET
2 - LOCK SET
3 - TRUNK LID
4 - TRUNK LID LATCH
5 - TRUNK LOCK CYLINDER