Chrysler 300M Service Manual page 224

LH
WATER PUMP - 3.5L (Continued)
INSTALLATION
(1) Clean all O-ring surfaces on pump and cover.
(2) Apply Mopar Dielectric Grease or the equiva-
lent silicone grease to the O-ring to facilitate assem-
bly. Install new O-ring on water pump (Fig. 32).
Fig. 32 WATER PUMP - 3.5L
1 - O-RING
2 - IMPELLER
3 - WATER PUMP BODY
(3) Position water pump to engine.
(4) Install mounting bolts and tighten to 12 N·m
(105 in. lbs.).
(5) Install timing belt (Refer to 9 - ENGINE/
VALVE TIMING/TIMING BELT AND SPROCKETS -
INSTALLATION).
(6) Install accessory drive belts (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION).
(7) Fill cooling system (Refer to 7 - COOLING -
STANDARD PROCEDURE).
ENGINE 7 - 37