5 - 32
BRAKES - BASE BRAKE SYSTEM
DISC BRAKE CALIPER - REAR (Continued)
ASSEMBLY
ASSEMBLY - CALIPER GUIDE PIN BUSHINGS
(1) Fold the guide pin bushing in half lengthwise
at the solid middle section (Fig. 49).
Fig. 49 Folded Caliper Guide Pin Bushing
1 - CALIPER GUIDE PIN BUSHING
NOTE: To avoid damage to the bushing, do not use
a sharp object to install the guide pin bushing.
(2) Insert the folded bushing into the caliper
mounting boss using your fingers (Fig. 50).
Fig. 50 Installing Caliper Guide Pin Bushing
1 - CALIPER
2 - BUSHING
(3) Unfold the bushing using your fingers or a
wooden dowel until the bushing is fully seated into
the caliper housing. The bushing flanges should be
seated evenly on both sides of the bushing hole (Fig.
51).
Fig. 51 Bushing Correctly Installed In Caliper
1 - BUSHING
2 - CALIPER
3 - BE SURE BOTH BUSHING FLANGES ARE FULLY SEATED
AROUND CALIPER BUSHING BORES.
(4) Lubricate the inside surfaces of the bushing
using Mopar Dielectric Grease or an equivalent.
LH