Chrysler 300M Service Manual page 363

8L - 34 LAMPS/LIGHTING - EXTERIOR
MULTI-FUNCTION SWITCH (Continued)
CONDITION
HAZARD WARNING
MALFUNCTION/SYSTEM
DOES NOT FLASH.
INDICATOR LAMP FLASHES
AT DOUBLE NORMAL RATE.
EXTERNAL LAMP DOES
NOT LIGHT.
SYSTEM DOES NOT FLASH
ON EITHER SIDE.
SYSTEM DOES NOT
CANCEL AFTER
COMPLETION OF TURN.
EXTERNAL LAMPS
OPERATE PROPERLY, NO
INDICATOR LAMP
OPERATION.
POSSIBLE CAUSES
1. FAULTY FUSE.
2. FAULTY FLASHER UNIT.
3. OPEN CIRCUIT IN FEED
WIRE TO SWITCH.
4. FAULTY CONTACT IN
SWITCH.
5. OPEN OR GROUNDED
CIRCUIT IN WIRING TO
EXTERNAL LAMPS.
1. OPEN CIRCUIT IN WIRE
TO EXTERNAL LAMP.
2. BURNED OUT LAMP.
1. FAULTY FUSE.
2. FAULTY FLASHER UNIT.
3. LOOSE BULKHEAD
CONNECTOR.
4. LOOSE OR FAULTY
REAR WIRING HARNESS
OR TERMINALS.
5. OPEN CIRCUIT TO
FLASHER UNIT.
6. OPEN CIRCUIT IN FEED
WIRE TO TURN SIGNAL
SWITCH.
7. FAULTY SWITCH
CONNECTION IN SWITCH.
8. OPEN OR GROUNDED
CIRCUIT IN WIRING TO
EXTERNAL LAMPS.
9. BURNED OUT LAMPS.
1. BROKEN CANCELLING
FINGER ON SWITCH.
2. BROKEN OR MISSING
CANCELLING CAM ON
CLOCK SPRING.
3. STICKING CANCELLING
FINGER ON MULTI-
FUNCTION SWITCH.
1. FAULTY INDICATOR
LAMP IN INSTRUMENT
CLUSTER.
CORRECTION
1. REPLACE FUSE.
2. REPLACE FLASHER UNIT.
3. REPLACE WIRING HARNESS. CHECK
CONNECTORS.
4. REPLACE MULTI-FUNCTION SWITCH.
5. REPLACE WIRING HARNESS.
1. REPLACE WIRING HARNESS.
2. REPLACE LAMP.
1. REPLACE FUSE.
2. REPLACE FLASHER UNIT.
3. TIGHTEN CONNECTOR.
4. REPLACE WIRING HARNESS.
5. CHECK CONNECTORS, REPLACE WIRING
HARNESS.
6. CHECK CONNECTORS, REPLACE WIRING
HARNESS.
7. REPLACE SWITCH.
8. REPLACE WIRING HARNESS.
9. REPLACE LAMPS.
1. REPLACE MULTI-FUNCTION SWITCH.
2. REPLACE CLOCK SPRING.
3. REPLACE MULTI-FUNCTION SWITCH.
1. REPLACE LAMP.
LH