Chrysler 300M Service Manual page 418

LH
WINDOW SWITCH
DIAGNOSIS AND TESTING - WINDOW SWITCH
For switch testing, remove the switch from its
mounting, refer to Switch Removal. Using an ohm-
meter, refer to Window Switch Continuity Charts to
determine if continuity is correct (Fig. 2) and (Fig. 3).
If the results are not obtained, replace the switch.
The master window switch has an Auto-Down fea-
ture. Actuation of the master switch to the second
down detent position will move the drivers side win-
dow completely down. The electronic switch will
automatically disconnect the motor approximately 1
second after the window bottoms out. Failure of the
electronic switch to detect stall current, will cause
the switch to disconnect after approximately 15 sec-
onds of operation. The auto down function can be
canceled by any movement of the switch.
Fig. 2 Master Window Switch
OFF
UP DRIVER'S
UP RIGHT
FRONT
UP LEFT
REAR
UP RIGHT
REAR
DOWN DRIVER'S
DOWN RIGHT
FRONT
DOWN LEFT
REAR
DOWN RIGHT
REAR
WINDOW LOCK
OFF
UP
DOWN
REMOVAL
MASTER SWITCH
INTREPID AND CONCORDE
PIN 8 to 10
(1) Open hood and disconnect the negative battery
PIN 8 to 11
cable remote terminal from the remote battery post.
PIN 8 to 7
(2) Remove driver's door trim panel. (Refer to 23 -
PIN 8 to 6
PIN 8 to 3
BODY/DOOR - FRONT/TRIM PANEL - REMOVAL).
PIN 8 to 4
(3) Remove three mounting screws.
PIN 8 to 9
(4) Remove switch and disconnect wire connector.
PIN 8 to 2
PIN 8 to 10
LHS and 300M
PIN 5 to 11
(1) Open hood and disconnect the negative battery
PIN 8 to 7
cable remote terminal from the remote battery post.
(2) Using a trim stick (special tool #C-4755) or
PIN 5 to 6
PIN 8 to 3
equivalent, gently pry up on switch trim bezel and
PIN 5 to 4
lift up and out of trim panel.
PIN 8 to 9
(3) Disconnect wire connector from rear of switch
and remove switch from vehicle.
PIN 5 to 2
PIN 8 to 11
PASSENGER SWITCH
PIN 5 to 10
(1) Open hood and disconnect the negative battery
PIN 8 to 6
cable remote terminal from the remote battery post.
(2) Remove passenger door trim panel. (Refer to 23
PIN 5 to 7
PIN 8 to 4
- BODY/DOOR - FRONT/TRIM PANEL - REMOV-
PIN 5 to 3
AL).
PIN 8 to 2
(3) Disconnect switch wire connector.
PIN 5 to 9
PIN 5 to 1
(4) Remove switch from bezel and vehicle.
POWER WINDOWS 8N - 23
Fig. 3 Passenger Window Switch
PIN 2 to 5
PIN 6 to 3
PIN 6 to 3
PIN 4 to 5
PIN 2 to 5
PIN 4 to 3