Chrysler 300M Service Manual page 341

8L - 12 LAMPS/LIGHTING - EXTERIOR
FOG LAMP (Continued)
CONDITION
FOG LAMPS DO NOT
ILLUMINATE
REMOVAL
INTREPID/300M
(1) Remove fog lamp housing screw in front fascia
and pull lamp housing from the fascia.
(2) Remove rear cover from fog lamp housing.
(3) Disengage wire clip holding bulb in fog lamp.
(4) Hinge wire clip out of bulb removal path.
(5) Pull bulb from lamp housing (Fig. 11) or (Fig.
12).
(6) Disengage wire connector from fog lamp wire
harness.
Fig. 11 FOG LAMP - INTREPID
1 - FOG LAMP UNIT
2 - REAR COVER
3 - FOG LAMP
CONCORDE
(1) Remove fog lamp housing screw in front fascia
and pull lamp housing from the front fascia.
(2) Disconnect wire connector from fog lamp socket
(Fig. 13).
(3) Rotate socket and pull bulb/socket from lamp
housing.
POSSIBLE CAUSES
1. Blown fuse for fog lamps.
2. No Z1-ground at fog lamps.
3. Faulty fog lamp switch.
4. Broken connector terminal or wire
splice in fog lamp circuit.
5. Broken connection between BCM
and fog lamp relay.
6. Faulty fog lamp relay.
7. Faulty Body Control Module.
1. Replace fuse, refer to Wiring Diagrams.
2. Repair circuit ground, refer to Wiring
Diagrams.
3. Replace headlamp switch.
4. Repair connector terminal or wire splice.
5. Test relay connectors in the Junction
Block and the circuit to BCM. Repair as
necessary.
6. Replace relay.
7. Replace Body Control Module.
Fig. 12 FOG LAMP - 300M
1 - FOG LAMP UNIT
2 - REAR COVER
3 - FOG LAMP
Fig. 13 FOG LAMP BULB - CONCORDE
1 - FOG LAMP BULB/SOCKET
2 - FOG LAMP
CORRECTION
LH