Chrysler 300M Service Manual page 359

8L - 30 LAMPS/LIGHTING - EXTERIOR
HEADLAMP UNIT (Continued)
1 - CENTER OF VEHICLE
2 - CENTER OF HEADLAMPS
3 - 15° CUT-OFF LINE
4 - FRONT OF HEADLAMP
• Gently pry back grille and remove the two bolts
to front crossmember. This will allow you to move the
crossmember forward, pivoting at the radiator grille,
to access the headlamp unit.
NOTE: Once the crossmember is loose, take care
not to scratch the fenders.
(6) Maneuver the headlamp unit to remove from
behind fascia. Gentle prying of fascia may be needed
to clear it enough to remove the headlamp unit.
(7) Disconnect the lamp connectors and transfer
lamps if replacing unit.
INTREPID
(1) Release hood latch and open hood.
(2) Disconnect and isolate the battery negative
cable.
(3) Remove jackscrews attaching headlamp to body
(Fig. 35).
(4) Remove headlamp from body.
(5) Disconnect wire connector from headlamp and
parking, side marker, and turn signal lamps.
(6) Remove headlamp housing from vehicle.
Fig. 34 HEADLAMP ALIGNMENT SCREEN - EXPORT
5 - 10 METERS (32.8 FT.)
6 - HORIZONTAL CUT-OFF LINE
7 - 100 MM
Fig. 35 HEADLAMP UNIT - INTREPID
1 - JACKSCREW
2 - HEADLAMP HOUSING
3 - BODY WIRE CONNECTOR
LH