Chrysler 300M Service Manual page 357

8L - 28 LAMPS/LIGHTING - EXTERIOR
HEADLAMP UNIT (Continued)
MODEL
CONCORDE
INTREPID
LHS
300M
1 - LOW BEAM CENTER LINE TO GROUND
2 - FRONT OF HEADLAMP
3 - 7.26 METERS (25 ft.)
HEADLAMP UNIT ADJUSTMENT
The low beam hot spot cut off should be within 2
inches above/below the horizontal center line, and to
the right of the vertical center line (Fig. 33). This
puts the low beam hot spot in the lower right quad-
rant of the aiming screen. Occasional stray filament
images should be disregarded while verifying aim.
Verify the vertical adjustment by checking the high
beams to ensure they are centered within ± 2 inches
relative to the horizontal center line. The low beams
should be shielded when checking high beams. Do
HEADLAMP UNIT ALIGNMENT MEASUREMENT TABLE
LOW BEAM CENTERLINE TO
GROUND
25.0 in.
25.7 in.
25.0 in.
24.8 in.
Fig. 33 HEADLAMP UNIT ALIGNMENT SCREEN
DISTANCE BETWEEN CENTERS (LOW
635.4 mm
652.4 mm
635.4 mm
629.3
4 - PREFERRED CUT OFF LOCATION ± 2 INS.
5 - CENTER OF VEHICLE
6 - CENTER OF HEADLAMP
NOT cover the headlamp(s) for extended periods, as
the heat may damage them. To adjust headlamp
alignment, rotate the alignment screws to achieve
the specified pattern.
BEAM)
54.2 in. 1376 mm
52.4 in. 1330 mm
49.3 in. 1254.5 mm
52.7 in. 1338.5 mm
LH