Installation; Combination Flasher Description; Operation; Diagnosis And Testing - Combination Flasher - Chrysler 300M Service Manual

LH
CENTER HIGH MOUNTED STOP LAMP UNIT (Continued)
Fig. 8 CHMSL - REAR SHELF - CONCORDE
1 - REAR SHELF TRIM PANEL
2 - ATTACHING SCREWS
(5) Remove CHMSL from decklid.

INSTALLATION

CONCORDE
(1) Place CHMSL in position on rear shelf upper
panel.
(2) Install fasteners to attach CHMSL to rear shelf
upper panel.
(3) Install rear shelf upper panel.
(4) Connect CHMSL wire connector to body har-
ness.
(5) Connect the battery negative cable and close
hood.
(6) Verify CHMSL operation.
INTREPID
(1) Place CHMSL in position on decklid.
(2) Install fasteners attaching CHMSL and appli-
que to decklid.
(3) Connect CHMSL wire connector to body har-
ness.
(4) Verify CHMSL operation.
(5) Install decklid cover.
300M
(1) Place CHMSL in position on decklid.
(2) Install fasteners attaching CHMSL to decklid.
(3) Connect CHMSL wire connector to body har-
ness.
(4) Verify CHMSL operation.
(5) Install decklid cover.
LAMPS/LIGHTING - EXTERIOR 8L - 9
COMBINATION FLASHER
DESCRIPTION
The Combination Flasher, also refered to as the
combo-flasher, is mounted to the in-line bracket
which is located to the right of the Junction Block.
The flasher can be removed by pulling in a rearward
direction. The left under panel silencer duct must be
removed to access the flasher. The combo-flasher is
black in color for ease of identification.

OPERATION

The Turn Signal and Hazard Warning Flasher is
combined into one unit called a Combination Flasher
(Combo-Flasher). The combo-flasher controls the
flashing of the hazard warning system and the turn
signal system. An inoperative bulb or incomplete
turn signal circuit will result in an increase in
flasher speed.
DIAGNOSIS AND TESTING - COMBINATION
FLASHER
(Refer to 8 - ELECTRICAL/LAMPS/LIGHTING -
EXTERIOR/MULTI-FUNCTION SWITCH - DIAG-
NOSIS AND TESTING) and the COMBINATION
FLASHER DIAGNOSIS table.

REMOVAL

(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 9).
Fig. 9 BATTERY NEGATIVE CABLE REMOVE/
1 - RIGHT STRUT TOWER
2 - AIR CLEANER INLET TUBE
3 - REMOTE TERMINAL
INSTALL