Washer Reservoir - Intrepid; Removal; Installation; Washer Reservoir Filler Tube - Chrysler 300M Service Manual

8R - 18 WIPERS/WASHERS
WASHER RESERVOIR -
INTREPID

REMOVAL

(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove the left headlamp assembly and set
aside. Refer to Electrical, Lamps/Lighting - Exterior,
Headlamp Unit (Intrepid), Removal.
(3) Remove the four retaining bolts to the washer
reservoir (Fig. 7).
(4) Disconnect the pump and sensor wire connec-
tors.
(5) Disconnect the washer hose.
(6) Disconnect the washer filler hose.
(7) Pivot the inboard side of the reservoir forward
and lift out of vehicle.
(8) If replacing the reservoir, you must transfer
the pump and sensor to the new reservoir (Fig. 8).
NOTE: When transferring pump and sensor, make
sure to use a new grommet for proper sealing and
to avoid leaks.

INSTALLATION

NOTE: When transferring pump and sensor, make
sure to use a new grommet for proper sealing and
to avoid leaks.
(1) If replacing the reservoir, you must transfer
the pump and sensor to the new reservoir (Fig. 8).
(2) Place reservoir into position in engine compart-
ment, pivot the inboard side of the reservoir rear-
ward.
(3) Connect the washer filler hose.
(4) Connect the washer hose.
(5) Connect the pump and sensor wire connectors.
(6) Install the four retaining bolts to the washer
reservoir (Fig. 7).
(7) Install the left headlamp assembly. Refer to
Electrical, Lamps/Lighting - Exterior, Headlamp Unit
(Intrepid), Installation.
(8) Connect the negative battery cable remote ter-
minal to the remote battery post.
WASHER RESERVOIR FILLER
TUBE
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Hoist vehicle.
(3) Remove front fascia as necessary (left side only
and use a 2x4 to prop left edge of fascia away from
body). Refer to Body for Removal.
(4) Reach up behind the washer reservoir and pull
the filler tube off the rear of the reservoir.
(5) Remove one screw attaching washer reservoir
filler tube to upper radiator support (Fig. 9).
(6) Pull filler tube and hose up through left fender
and remove.
Fig. 9 WASHER RESERVOIR FILLER TUBE
1 - SPEED CONTROL SERVO

2 - WASHER RESERVOIR FILLER TUBE

INSTALLATION
(1) Place filler tube in engine compartment and
route through left fender.
(2) INstall the one screw attaching washer reser-
voir filler tube to upper radiator support (Fig. 9).
(3) Reach up behind the washer reservoir and
install the filler tube on the rear of the reservoir.
(4) Install the front fascia as necessary (left side
only and use a 2x4 to prop left edge of fascia away
from body). Refer to Body for Installation.
(5) Lower vehicle off hoist.
(6) Connect the negative battery cable remote ter-
minal to the remote battery post.
LH