Clearing A Backup Alarm - Avaya Partner Administration Manual

15.3 Clearing a Backup Alarm

If an automatic backup fails, a backup failure alarm message appears instead of the system date and time at idle
extensions 10 and 11. After correcting the problem that caused the failure, you can clear the backup failure alarm.
To clear a backup alarm (ETR 18D/34D)
1. At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2. Dial #123. The phone displays Clear Backup Alarm.
3. Press Enter 14 to clear the backup alarm.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To clear a backup alarm (1408/1416 Phone)
1. At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2. Use the up or down
Select.
3. Use the up or down
Select.
· Alternatively, dial # and the same code as used by ETR phones for
4. Use the up or down
Select.
5. To clear the alarm press Proceed.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
PARTNER Phone Administration
IP Office PARTNER Version
arrow buttons to scroll the display to System Administration. When displayed, press
arrow buttons to scroll the display to System Parameters. When displayed, press
arrow buttons to scroll the display to Clear Backup Alarm. When displayed, press
System Maintenance: Remote Administration Password
system administration .
7
Page 153
- Issue 1b (22 February 2010)