Remote Administration Password - Avaya Partner Administration Manual

15.2 Remote Administration Password

This password is used for system administration from a PC using the IP Office Manager application.
To program a remote administration password (ETR 18D/34D)
1. At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2. Dial #730.
3. If a system password
password.
4. The current password is displayed or dashes if no password has been set.
5. Enter or change the password.
· Enter a character by pressing the indicated button until that character is displayed. If you pause more than 1
second after press a button, the cursor will move onto the next space.
1 1!"$%&'()+,-./
4
7
* *:;<=>?@[\]^_`
· Do not use punctuation characters such as #, ?, /, -, _ and , in the password. Note that the password is case
sensitive and must be unique. French and Spanish languages do not offer accented characters.
6. To save the password, press
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To program a remote administration password (1408/1416 Phone)
1. At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2. Use the up or down
Select.
4. Dial #730.
5. If a system password
proceed.
6. The display will show Remote password:.
· Enter a character by pressing the indicated button until that character is displayed. If you pause more than 1
second after press a button, the cursor will move onto the next space.
1 1!"$%&'()+,-./
4
7
* *:;<=>?@[\]^_`
· Do not use punctuation characters such as #, ?, /, -, _ and , in the password. Note that the password is case
sensitive and must be unique. French and Spanish languages do not offer accented characters.
7. Use the dial pad to enter an password of up to 8 characters. When completed press Enter. To remove the
characters entered so far press Clear.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
PARTNER Phone Administration
IP Office PARTNER Version
has been set, the prompt Enter Sys Password: is displayed. Enter the four digit system
43
4ghiGHI
7pqrsPQRS
Enter . The bottom line of the display shows the password as it has been entered.
14
arrow buttons to scroll the display to System Administration. When displayed, press
has been set for the system, you will be prompted to enter that password before you can
43
4ghiGHI
7pqrsPQRS
2 2abcABC
5 5jklJKL
8 8tuvTUV
0 0 Space
2 2abcABC
5 5jklJKL
8 8tuvTUV
0 0 Space
3 3defDEF
6 6mnoMNO
9 9wxyzWXYZ
# #
3 3defDEF
6 6mnoMNO
9 9wxyzWXYZ
# #
- Issue 1b (22 February 2010)
Page 152