Copy Extension Settings; System Maintenance - Avaya Partner Administration Manual

15.1 Copy Extension Settings

Set up your system by programming one extension for each type of telephone in the system. You can then use copy
settings to program other telephones of the same type. For example, you can program one ETR 18D telephone and then
copy its settings to any other extensions that have ETR 18 telephones.
To copy settings from one extension to another of the same type (ETR 18D/34D)
1. At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2. Dial #399. The phone displays Copy Settings.
3. At the Extension prompt, enter the source extension to copy from.
4. At the next Extension prompt, enter the target extension to copy to, any extension except the source extension
is valid.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To copy settings from one extension to another of the same type (1408/1416 Phone)
1. At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2. Use the up or down
Select.
4. Dial #399. The display will show Copy Settings:.
5. At the Extension: prompt enter the number of the extension from which you want to copy the settings.
6. At the next Extension: prompt enter the number of the extension to which you want to transfer the copy.
7. If Proceed is not displayed or there is a problem, additional text messages may be displayed.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
PARTNER Phone Administration
IP Office PARTNER Version
arrow buttons to scroll the display to System Administration. When displayed, press

System Maintenance:

Page 151
- Issue 1b (22 February 2010)