Debug Platform Qos-Acl-Tcam - Cisco Catalyst Blade Switch 3130 Reference Manual

debug platform qos-acl-tcam

debug platform qos-acl-tcam
Use the debug platform qos-acl-tcam privileged EXEC command to enable debugging of the quality
of service (QoS) and access control list (ACL) hardware memory manager software. Use the no form of
this command to disable debugging.
Syntax Description
all
ctcam
errors
labels
mask
rpc
tcam
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines
The undebug platform qos-acl-tcam command is the same as the no debug platform qos-acl-tcam
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
B-54
debug platform qos-acl-tcam {all | ctcam | errors | labels | mask | rpc | tcam}
no debug platform qos-acl-tcam {all | ctcam | errors | labels | mask | rpc | tcam}
Display all QoS and ACL ternary content addressable memory (QATM) manager
debug messages.
Display Cisco TCAM (CTCAM) related-events debug messages.
Display QATM error-related-events debug messages.
Display QATM label-related-events debug messages.
Display QATM mask-related-events debug messages.
Display QATM remote procedure call (RPC) related-events debug messages.
Display QATM hardware-memory-related events debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Cisco Catalyst Blade Switch 3130 for Dell Debug Commands
OL-13271-01