Cisco Catalyst Blade Switch 3130 Reference Manual page 114

diagnostic schedule
Usage Guidelines
Use these guidelines when scheduling testing:
•
•
•
•
•
•
Note If you are running a diagnostic test that has the reload attribute on a switch in a stack, you could
potentially partition the stack depending on your cabling configuration. To avoid partitioning your stack,
enter the
Examples This example shows how to schedule diagnostic testing for a specific day and time on stack member 3 when
this command is entered on a stack master:
Switch(config)# diagnostic schedule switch 3 test 1,2,4-6 on november 3 2006 23:10
This example shows how to schedule diagnostic testing to occur weekly at a specific time on a
standalone switch:
Switch(config)# diagnostic schedule test TestPortAsicMem weekly friday 09:23
Related Commands Command
show diagnostic
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
2-86
name—Enter the show diagnostic
the test ID list.
test-id—Enter the show diagnostic
test-id-range—Enter the show diagnostic
ID list. Enter the range as integers separated by a comma and a hyphen (for example, 1,3-6 specifies
test IDs 1, 3, 4, 5, and 6).
hh:mm—Enter the time as a 2-digit number (for a 24-hour clock) for hours:minutes; the colon (:) is
required, such as 12:30.
For mm dd yyyy:
mm—Spell out the month, such as January, February, and so on, with upper case or lower case
–
characters.
dd—Enter the day as a 2-digit number, such as 03 or 16.
–
yyyy—Enter the year as a 4-digit number, such as 2006.
–
day-of-week—Spell out the day of the week, such as Monday, Tuesday, and so on, with upper case
or lower case characters.
show switch detail privileged EXEC command to verify the stack configuration.
Chapter 2 Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
content privileged EXEC command to display the test names in
content command to display the test numbers in the test ID list.
content command to display the test numbers in the test
Description
Displays online diagnostic test results.
OL-13271-01