Ipv6 Traffic-Filter - Cisco Catalyst Blade Switch 3130 Reference Manual

ipv6 traffic-filter

ipv6 traffic-filter
Use the ipv6 traffic-filter interface configuration command on the switch stack or on a standalone
switch to filter IPv6 traffic on an interface. The type and direction of traffic that you can filter depends
on the feature set running on the switch stack. Use the no form of this command to disable the filtering
of IPv6 traffic on an interface.
Note This command is available only if you have configured a dual IPv4 and IPv6 Switch Database
Management (SDM) template on the switch.
Syntax Description
access-list-name
in
out
Defaults Filtering of IPv6 traffic on an interface is not configured.
Command Modes
Interface configuration
Command History Release
12.2(40)EX1
Usage Guidelines
To configure the dual IPv4 and IPv6 template, enter the sdm prefer dual-ipv4-and-ipv6 {default | vlan)
global configuration command and reload the switch.
You can use the ipv6 traffic-filter command on physical interfaces (Layer 2 or Layer 3 ports), Layer 3
port channels, or switch virtual interfaces (SVIs).
If the switch stack is running the advanced IP services feature set, you can apply an ACL to outbound or
inbound traffic on Layer 3 interfaces (port ACLs), or to inbound traffic on Layer 2 interfaces (router
ACLs). If the switch stack is running the IP services or IP base feature set, you can apply ACLs only to
inbound management traffic on Layer 3 interfaces. Switches running the IP services or IP base feature
set do not support port ACLs.
If any port ACL (IPv4, IPv6, or MAC) is applied to an interface, that port ACL is used to filter packets,
and any router ACLs attached to the SVI of the port VLAN are ignored.
Cisco Catalyst Blade Switch 3130 for Dell Command Reference
2-222
ipv6 traffic-filter access-list-name {in | out}
no ipv6 traffic-filter access-list-name {in | out}
Specify an IPv6 access name.
Specify incoming IPv6 traffic.
Specify outgoing IPv6 traffic.
Note
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3130 for Dell Cisco IOS Commands
The out keyword is not supported for Layer 2 interfaces (port
ACLs). If the switch stack is running the IP services or IP base
feature set, the out keyword is not supported for Layer 3 interfaces.
OL-13271-01