Siemens SIMATIC S7-200 System Manual page 336

S7-200 Programmable Controller System Manual
Table 10-8 Error Values Returned by MODx_MSG and MODx_XFR Instructions, continued
Error
UCP - - SMS message errors returned by service provider (continued)
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
Data transfer errors
53
54
55
56
57
58
59
60 to 127
Instruction use errors
128
129
322
Description
Deferred delivery not allowed
New AC not valid
New legitimization code not allowed
Standard text not valid
Time period not valid
Message type not supported by system
Message too long
Requested standard text not valid
Message type not valid for pager type
Message not found in SMSC
Reserved
Reserved
Subscriber hang up
Fax group not supported
Fax message type not supported
Message timeout (no response from remote device)
Remote CPU busy with upload or download
Access error (memory out of range, illegal data type)
Communications error (unknown response)
Checksum or CRC error in response
Remote EM 241 set for callback (not allowed)
Remote EM 241 rejected the provided password
Reserved
Cannot process this request. Either the Modem module is busy with another request, or
there was no START pulse on this request.
Modem module error:
The location of the Modem module or the Q memory address that was configured
S
with the Modem Expansion wizard does not match the actual location or memory
address
Refer to SMB8 to SMB21 (I/O Module ID and Error Register)
S