Configuring Interfaces, Zones, And Policies With J-Web; Configuring The Hostname; Configuring Interfaces; Configuring Zones And Assigning Interfaces - Juniper SRX5600 Hardware Manual

SRX5600 Services Gateway Hardware Guide

Configuring Interfaces, Zones, and Policies with J-Web

88
root@#
Set the root authentication password by entering a cleartext password, an encrypted
3.
password, or an SSH public key string (DSA or RSA).
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
Commit the configuration to activate it on the device.
4.
[edit]
root@# commit
Configure the IP address and prefix length for the Ethernet management interface on
5.
the device.
[edit]
root@# set interfaces fxp0 unit 0 family inet address address/prefix-length
Configure the default route.
6.
[edit]
root@# set routing-options static route 0.0.0.0/0 next-hop gateway
Enable Web access to launch J-Web.
7.
[edit]
root@# set system services web-management http
Commit the configuration changes.
8.
[edit]
root@# commit
You can configure hostnames, interfaces, zones, and security policies using J-Web.
Before you begin:
Ensure you have configured the IP address, root authentication, and default route. See
"Configuring Root Authentication and the Management Interface from the CLI" on
page 87
Enable HTTP on the device to access J-Web. See
and the Management Interface from the CLI" on page 87
Configure the device with J-Web using the following procedures.
Configuring the Hostname on page 89
Configuring Interfaces on page 89
Configuring Zones and Assigning Interfaces on page 89
Configuring Security Policies on page 90
"Configuring Root Authentication
Copyright © 2014, Juniper Networks, Inc.