An Auxiliary Device - Juniper SRX5600 Hardware Manual

Connecting the SRX5600 Services Gateway to a Management Console or an Auxiliary Device
Related
Documentation
Copyright © 2014, Juniper Networks, Inc.
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate CONSOLE port on the Routing Engine. To use a laptop, modem, or other
auxiliary device, connect it to the
cable with an RJ-45 connector. One serial cable with an RJ-45 connector and a DB-9
connector is provided with the services gateway. To connect a device to the
port and another device to the
To connect a management console or auxiliary device:
Plug the RJ-45 end of the serial cable
1.
into the AUX port or CONSOLE
the ports.
Figure 34: Auxiliary and Console Ports
Figure 35: Routing Engine Console and Auxiliary Cable Connector
Plug the female DB-9 end into the device's serial port.
2.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Tools and Parts Required for SRX5600 Services Gateway Connections on page 63
Overview of Installing the SRX5600 Services Gateway on page 39
Connecting the SRX5600 Services Gateway to a Network for Out-of-Band Management
on page 64
Chapter 8: Connecting the SRX5600 Services Gateway
port on the Routing Engine. Both ports accept a
AUX
AUX port, you must supply an additional cable.
(Figure 35 on page 65
port on the Routing Engine.
CONSOLE
shows the connector)
Figure 34 on page 65 shows
65