Static Route Edit - ZyXEL Communications AMG1302-T10A User Manual

12.2.1 Static Route Edit

Use this screen to configure the required information for a static route. Select a static route index
number and click Edit. The screen shown next appears.
Figure 90 Advanced > Static Route: Edit
The following table describes the labels in this screen.
Table 60 Advanced > Static Route: Edit
LABEL
Static Route Setup
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Back
Apply
Cancel
AMG1302-T10A User's Guide
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 12 Static Route
161