Turn Signal And Main Beam Light; Automatic Driving Lamp Control - Skoda Octavia Owner's Manual

Turn signal and main beam light


First read and observe the introductory information and safety warn-
ings on page 43.
The parking light and headlight flasher are also operated with the operating lever.
Switching on the right and left
 
›
Put the lever into position or where applicable
A
If you only wish to flash three times (convenience turn signal), briefly push the
lever to the pressure point or where applicable
A
The convenience turn signal can be activated/deactivated in the Infotain-
ment » operating instructions for Infotainment, chapter Setting vehicle systems
(CAR button).
Switching the main beam on/off

›
Turn the light switch into position  or 
›
Place the lever in position (spring-tensioned position)
C
›
The main beam can be switched off by pulling the lever into position
tensioned positioned).
On vehicles with Headlight assist, when the lever is put into position
sistant is activated » page 47.
Switching on the headlight flasher (main beam)
›
Place the lever in position .
D
Switching on the  parking light
›
Switch off the ignition.
›
Place the lever into the position
go » Fig. 26 - the side light on the right/left side of the vehicle is switched on.
Fig. 26
Operating lever: Turn signal and
main beam operation
turn signal light
as far as it can go
B
and release again.
B
» Fig. 25 on page 44.
» Fig. 26.

or where applicable as far as it can
A B
WARNING
Only use the main beam or the headlight flasher if other road users will not be
dazzled.
Note
The turn signal light automatically switches itself off when driving around a
■
curve or after making a turn.
The warning light flashes at twice its normal rate if a bulb for the turn signal
■
light fails.
If the right or left turn signal light has been switched on and the ignition is
■
switched off, the parking light is not automatically switched on.

Automatic driving lamp control

» Fig. 26.

First read and observe the introductory information and safety warn-
ings on page 43.
(spring-
D
If the light switch is in position , the the side lights and low beam and number
, the As-
C
plate light are switched on/off automatically based on the current light condi-
tions.
The light is regulated based on the data provided by the light sensor in the rear
mirror holder. The sensitivity of the light sensor can be activated/deactivated in
the Infotainment
cle systems (CAR button).
Activating
›
Turn the light switch into position 
Fig. 27
Dash panel: Light switch
» operating instructions for Infotainment, chapter Setting vehi-
» Fig. 27.


45
Lights and visibility