Turn Signal And Main Beam; Automatic Driving Lamp Control - Skoda Fabia Owner's Manual

›
Pull the indicator / main beam lever towards the steering wheel, push down
and hold in this position.
›
Switch on the ignition.
›
Hold the operating lever in this position for min. 3 seconds after switching on
the ignition.
The deactivation of the function is confirmed by an audible signal.
Activating on vehicles without Infotainment
›
Switch off the ignition.
›
Pull the indicator / main beam lever towards the steering wheel, push up and
hold in this position.
›
Switch on the ignition.
›
Hold the operating lever in this position for min. 3 seconds after switching on
the ignition.
The activation of the function is confirmed by an audible signal.
WARNING
Always switch on the low beam when the visibility is poor.

Turn signal and main beam


Read and observe on page 59 first.
Lever positions » Fig. 48
When the right turn signal light is switched on, the warning light flashes in
A
the instrument cluster

When the left turn signal light is switched on, the warning light flashes in
B
the instrument cluster

Fig. 48
Operating lever: Turn signal and
main beam operation
Switch on main beam (spring setting) - the warning light illuminates in the
C
instrument cluster

Switching off main beam / switching on headlamp flasher (spring-loaded
D
position)
The main beam can only be switched on when the low beam lights are on.
The headlight flasher can be operated even if the ignition is switched off.
The turn signal light switches itself off automatically when driving around a
curve or after making a turn.
"Convenience turn signal"
When the control lever is lightly pressed to the pressure point
the respective turn-signal lamp flashes three times.
If during the "comfort flashing" the operating lever in the opposite side is
pressed, then the blinking stops.
The "Lane change flash" can be activated/deactivated in the Infotainment
» Owner´s Manual Infotainment, chapter CAR - vehicle settings.
WARNING
Only turn on the main beam or the headlight flasher if other road users will
not be dazzled.

Automatic driving lamp control


Read and observe on page 59 first.
The light switch is in position » Fig. 49
the automatic switch on / off the lights corresponding to the light or weather
conditions (rain) takes place.
or then
A B
Fig. 49
Light switch: AUTO position
then depending on the equipment
Lights and visibility

61