Skoda Octavia Owner's Manual page 187

Škoda octavia
Hide thumbs Also See for Octavia:
Table of Contents

Advertisement

Full wheel trim
First read and observe the introductory information and safety warn-
ings
on page 181.
Pulling off
Hook the clamp found in the vehicle tool kit into the reinforced edge of the
wheel trim.
Push the wheel wrench through the clamp, support on the tyre and pull off the
wheel trim.
Install
Press the wheel trim onto the wheel rim at the valve opening provided.
Then press the trim into the wheel rim until its entire circumference locks cor-
rectly in place.
CAUTION
Use the pressure of your hand, do not knock the full wheel trim! Avoid heavy
knocks when the trim is not yet inserted in the wheel rim. This could cause dam-
age to the guide and centring elements of the trim.
Ensure that the anti-theft wheel bolt has been installed
Securing wheels against theft.
If wheel trims are retrofitted it must be ensured that an adequate flow of air is
assured to cool the brake system.
Wheel bolts
First read and observe the introductory information and safety warn-
ings
on page 181.
correctly» page
192,
Fig. 158
Remove the cap
Pulling off
Push the plastic clip sufficiently far onto the cap until the inner catches of the
clip are positioned at the collar of the cap
Remove the cap.
Install
Push the caps onto the wheel bolts up to the stop.
The wheel bolt caps are housed in a plastic box in the spare wheel or in the stor-
age space for the spare wheel.
Tyre control display
First read and observe the introductory information and safety warn-
ings
on page 181.
Calibration
After changing the tyre inflation
after changing one or several wheels, the position of a wheel on the vehicle or
when the warning light lights up while driving, a calibration of the system must
be carried out as follows:
Inflate all of the tyres to the specified inflation pressure
Switch on the ignition.
Start the system calibration.
On vehicles with Infortainment
ter Setting vehicle systems (CAR button).
On vehicles with the radio preinstallation.
Press and hold the button
 
» Fig.
158.
Fig. 159
Button for setting the tyre infla-
tion pressure control value
pressure» page 182,
in section Introduction,
» page
182.
»
operating instructions for Infotainment, chap-
» Fig. 159
for longer than 2 seconds.
185
Wheels

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents