Skoda Octavia Owner's Manual page 120

›
If the arrow in the display is flashing to the front
move the selector lever into the position D.
›
Wait until the steering wheel automatically turns into the required position and
then carefully drive forwards.
›
When the arrow in the display is flashing towards the rear
the reverse gear or move the selector lever to the position R.
›
Wait until the steering wheel automatically turns into the required position and
then carefully reverse.
You can repeat these steps several times.
As soon as the parking procedure is completed, an audible signal sounds and the
following message appears in the instrument cluster display:
Steering interven. stopped. Take over steering!
Automatic termination
The system terminates the parking procedure if one of the following cases arises:
›
Speed of around 7 km/h repeatedly exceeded during the parking procedure;
›
Time limit of 6 minutes exceeded for the parking procedure;
›
System button pressed;
›
TCS system switched off;
›
Automatic steering procedure interrupted by the driver (stopping the steering
wheel);
›
Reverse gear disengaged or selector lever taken out of position R when revers-
ing into the parking space;
›
Shift the selector lever to P position;
›
when there is a system fault (system temporarily not available).
Manoeuvring out of a parallel parking space

First read and observe the introductory information and safety warn-
ings on page 116.
Manoeuvring out
›
Press the button » Fig. 109 on page 117 once.

›
Activate the turn signal for side of the vehicle where the parking space is out of
which you wish to manoeuvre.
›
Engage reverse gear.
›
As soon as the following message is shown in the information display: Steering
int. active. Check around veh.!, let go of the steering wheel and the steering is
taken over by the system.
›
Observe the direct vicinity of the vehicle and reverse carefully.
118
Using the system
» Fig. 110 , engage 1st gear or
» Fig. 110 - , engage

›
Follow the instructions of the system shown in the instrument cluster display.
As soon as the manoeuvring procedure is completed, an audible signal sounds
and the following message appears in the instrument cluster display:
Steering interven. stopped. Take over steering!
Automatic termination
The system terminates the manoeuvring procedure if one of the following cases
arises:
›
Speed of around 7 km/h repeatedly exceeded during the manoeuvring proce-
dure;
›
System button pressed;
›
TCS system switched off;
›
Automatic steering procedure interrupted by the driver (stopping the steering
wheel);
›
when there is a system fault (system temporarily not available).
Automatic brake assist

First read and observe the introductory information and safety warn-
ings on page 116.
The system provides assistance to the driver with automatic brake assist. The au-
tomatic brake assist does not exempt the driver from his/her responsibility for
the accelerator, brake and clutch.
Automatic braking for preventing cancellations caused by excessive speeds
To prevent the speed from exceeding 7 km/h and to subsequently prevent can-
cellation of the parking procedure, automatic brake support is initiated. The park-
ing procedure can be resumed after automatic braking.
Automatic braking takes place only once per parking procedure.
Automatic braking for damage limitation
The system detects an imminent collision based on the driving speed and the dis-
tance from the obstacle, automatic brake support is initiated.
The system function is ended after this automatic brake assist for damage limita-
tion.

