Start/Stop - Skoda Octavia Owner's Manual

Decreasing the speed
The stored speed can be reduced by pressing the rocker button
page 120 into the position SET.
The speed will decrease continuously, if the rocker button is pressed and held in
the SET position. Release the rocker button once the desired speed is reached.
The set speed is then stored in the memory.
If the rocker button is released at a speed of less than 30 km/h, the speed is not
stored and the memory is erased. The speed must then be stored again by press-
ing the rocker button in the position SET after increasing the speed of the ve-
B
hicle to more than 30 km/h.
The speed can also be reduced by depressing the brake pedal, which temporarily
deactivates the system.
Switching off the cruise control system temporarily

First read and observe the introductory information and safety warn-
ings on page 119.
The cruise control system is temporarily switched off by pressing the switch
A » Fig. 111 on page 120 into the spring-tensioned position CANCEL or by de-
pressing the brake pedal.
The set speed remains stored in the memory.
Briefly press the rocker button into the position RES to resume the stored
B
speed after the brake pedal is released.
Switching off the cruise control system completely

First read and observe the introductory information and safety warn-
ings on page 119.
›
Turn the switch » Fig. 111 on page 120 into the OFF position.
A
Displays in the instrument cluster display
» Fig. 111 on
B

Fig. 112 Instrument cluster display: GRA status indications

First read and observe the introductory information and safety warn-
ings
GRA status indications
The saved speed is indicated in small numbers. The GRA is temporarily
A
switched off.
System fault. Seek help from a ŠKODA specialist garage.
B
The speed memory is blank.
C
The saved speed is indicated in big numbers. The GRA is switched on.
D


START/STOP


Introduction
This chapter contains information on the following subjects:
Starting/shutting down the engine

Operational conditions of the system
Manually activating/deactivating the system
Information for the driver
The START-STOP system helps you to save fuel while at the same time reducing
harmful exhaust emissions and CO
The function is automatically activated each time the ignition is switched on.
on page 119.
» Fig. 112.
emissions.
2

122
123
124
124

121
Assist systems