Note
Immediately replace the wheel that was repaired using the breakdown kit or con-
sult a ŠKODA specialist garage about repair possibilities.
Breakdown kit
Fig. 166 Components of the breakdown kit
First read and observe the introductory information and safety warn-
ings
on page 192.
The kit is located in a box under the floor covering in the luggage compartment.
Explanation of graphic
Valve remover
1
Sticker with speed designation "max. 80 km/h"
2
3
Inflation hose with plug
Air compressor
4
Tyre inflation hose
5
Tyre inflation pressure indicator
6
Air release valve
7
ON and OFF switch
8
12 volt cable connector
9
Tyre inflator bottle with sealing agent
10
Replacement valve core
11
The valve remover
has a slot at its lower end which fits into the valve core.
1
This is the only way in which you can remove and re-install the valve core from
the tyre valve. The same also applies to the replacement valve core
Note
Observe the manufacturer's usage instructions for the breakdown kit.
■
A new bottle of sealant can be purchased from ŠKODA Original Parts.
■
Preparing to use the breakdown kit
First read and observe the introductory information and safety warn-
ings
on page 192.
The following preparatory work must be carried out before using the breakdown
kit.
›
Park the vehicle as far away as possible from the flow of traffic. Park on as flat
and firm a surface as possible.
›
If you are in flowing traffic, switch on the hazard warning light system and set
up the warning triangle at the prescribed distance! The national legal require-
ments must be observed.
›
Let all of the occupants get out. While changing a tyre, the occupants of the
vehicle should not stand on the road (instead they should remain behind a crash
barrier).
›
Switch off the engine and move the gearshift lever into Neutral or move the se-
lector lever on the automatic gearbox into position P.
›
Firmly apply the handbrake.
›
Check that you can carry out the repairs with the breakdown kit
›
If a trailer is connected, remove it.
›
Remove the breakdown kit from the luggage compartment.
›
Stick the sticker
» Fig. 166
2
er.
›
Unscrew the valve cap.
›
Use the valve remover
to unscrew the valve core and place it on a clean sur-
1
face (rag, paper, etc.).
» page
on page 193 on the dash panel in view of the driv-
Do-it-yourself
.
11
192.
193