Table of Contents
Advertisement
Programming
10
Correcting the engaging depth
.06.02
10 - 15
Input higher than preset
9
Fig. 10 - 06
Input a new angle setting, e.g. 5, in order to obtain a seam pattern corresponding with
Fig. 10-06 or accept the preset amount, then
press enter key immediately.
The input seam pattern is accepted by selecting the SEWING mode.
Engaging depth correct
Fig. 10 - 07
Correction of the seam pattern in Fig. 10-08 can be made on the control panel for
engaging depth quick-change from –1.2 mm to +1.2 mm.
See Chapter 7.04 Control panel for engaging depth quick-change.
Curved dart
Input lower than preset
Engaging depth too little
Fig. 10 - 08
(engaging depth
exaggreated)
Advertisement
Table of Contents
