Table of Contents
Advertisement
Making up styling parts
Fig. 13 - 06
Fig. 13 - 07
13 - 4
Mark intersection "A" using two radiuses (Fig. 13-07):
R1 = dart length AL + 7 mm
R2 = half dart length AT + 3 mm.
Scribe outer contour of guide blade as shown in Fig. 13-08 and cut out contour.
De-burr and polish cut edges.
Secure guide blade to guide-blade carrier.
Carry out a sewing test.
If necessary adjust guide blade on eccentric pin.
Advertisement
Table of Contents
