Entering The Loading Point - Pfaff 3566-2/02 Instruction Manual

10

Entering the loading point

.04
The loading point can be specified automatically or manually.
For waistband pleats, for example, the loading point can be shifted manually so that the
seam end is not located at the end of the guide blade.
Example of an automatically specified loading point:
Seam length (SL) = 100 mm; loading point automatic = LP: AUT
Example of a manually specified loading point:
Seam length (SL) = 100 mm, loading point manual = LP: MAN
Input value = 150 mm = seam length + value for loading point shift ( here 50 mm )
Guide blade
Loading point
Fig. 10 - 02
If the loading point is input manually, the length of the guide blade must
correspond with the value of the input!
Guide blade
Loading point
Fig. 10 - 03
A manually specified loading point always stays the same when the seam
length is changed; an automatically specified loading point changes with a
change of seam length.
SL
SL + 50 mm
SL
Programming
10 - 10