Table of Contents
Advertisement
9
Setting up
9
Inserting the needle
.01
long needle groove
Fig. 9 - 01
Switch on the machine.
Select the SEWING mode.
Press the threading aid key.
The luminous diode in the key lights up, the work-holder bar and presser foot are
lowered and sewing start is inhibited.
Loosen screw 1 and insert needle 2 as shown in Fig. 9-01.
Tighten screw 1.
Press the threading aid key.
The luminous diode goes out, work-holder bar and presser foot are raised and the
machine is ready for operation again.
All instructions and regulations in this manual must be obserbed.
Special attention must be given to all safetyl regulations!
All setting-up work must only be done by personnel with the necessary
training. For all setting-up work the machine must be isolated from the power
supply by turning off the main switch or removing the machine plug from the
electric power socket!
Only use needle system
134 KK in sizes Nm 90, 100 or
110!
1
2
Setting up
9 - 1
Advertisement
Table of Contents
