Table of Contents
Advertisement
Adjustment
13
Adjusting the synchronizer of the engaging cylinder
.45
● Open the button clamp with parameter "603" (Pos. "12" at value "1").
● Move the stop cylinder back with parameter "603" (Pos. "11" at value "1").
● Close the button clamp with parameter "603" (Pos. "12" at value "0").
● Select parameter "602".
● Move switch S26 (screw 1) from the right until the sixth figure from the right changes
● Extend the loading cylinder with parameter "603" (Pos. "9" at value "1").
● Move the button holder to the loading station with parameter "603" (Pos. "10" at value
● Select parameter "602".
● Move switch S23 (screw 2) from the left until the third figure from the right changes
104
S23
Fig. 13 - 43
from "0" to "1".
"1").
from "0" to "1".
The machine remains switched on and connected to the pneumatic system
for further adjustments.
S26
1
2
Advertisement
Table of Contents
