Table of Contents
Advertisement
Programming
2 - TIMES
. . .
10 - 5
5 - BOBBIN THREAD MONITOR DELAY
For entering a number of stitches in which the bobbin thread monitor is de-activated
during sewing start.
6 - NUMBER OF SLOW STARTING STITCHES
For entering the number of stitches to be made at reduced speed during sewing start.
7 - CARRIAGE START (NIM = needle in material)
Needle comes out
of material,
carriage start at
approx. 270°
fixed range of 180°
Fig. 10 - 01
The command for starting the carriage is output when the needle enters the material,
but the carriage movement does not begin until the needle comes out of the material
(fixed at 180° later). The timing of the output of the carriage start signal can be set
from 0 to 360°.
During a basting seam the Class 3566 feeds intermittently.
8 - MONITORED STITCHES, NEEDLE THREAD
For setting the number of stitches during which a thread disturbance is to be ingnored.
A low number of stitches set is equal to a high sensitivity of the needle-thread monitor.
1 - TIME FOR AIRBLAST
The duration of the airblast after thread trimming for blowing the workpiece out is set
here.
The setting is changed by pressing the plus/minus keys or the number keys.
needle at t.d.c.
0°
Needle in
material,
Needle enters material,
carriage stops,
command for carriage
start start is given at
approx. 90°
Advertisement
Table of Contents
