Connecting The Set To The Lan - Alcatel-Lucent OmniPCX Office Installation Manual

This paragraph applies to OMC configuration of sets initializing in static mode. In dynamic
(DHCP) mode, the following operation is not mandatory but the server certificate must be
exported from the Alcatel-Lucent OmniPCX Office Communication Server to the PC and can
then be uploaded to the 4135 IP Conference Phone.
To create a 4135 IP Conference Phone:
1. In OMC, go to Users/Base stations List.
2. Select a No., IP access, enter a name and click the Add button.
3. Select IP terminal and click OK.
4. Select the newly created user in the list and select 4135 IP Conference Phone in the
combo box type.
5. Click the Modify button.
6. Click the newly created user to open the User dialog box.
7. Click the IP/SIP button and enter the MAC adress of the set in the IP Parameters tab.
8. If needed, in the SIP Parameters, click the SIP password reset button to get a new
password.

Connecting the set to the LAN

Note:
the set is supplied via Ethernet, so make sure using a 802.3af standard-compatible switch.
To connect the set to the LAN:
1. Turn the set over so that you can see its base.
2. Plug the RJ45 cable into the set's LAN connector.
3. Connect the RJ45 cable to the LAN.
Initializing the sets
This section describes how to:
- Select the initialization mode
- Initialize the 4135 IP Conference Phone set
Selecting the initialization type
The default initialization is dynamic.
To select the initialization type, refer to the table below.
If
You have a DHCP
server
table 4.17: Initialization type selection
Then the required
initialization mode is
Dynamic or Proprietary
dynamic
Further information
- Refer to Configuring the DHCP server
for dynamic initialization
- In the case of Proprietary dynamic
mode, the IP address of the set must be
provided by the Proprietary router.
4-43