Commissioning The Set - Alcatel-Lucent OmniPCX Office Installation Manual

4.4.1.1.2 Commissioning the set

This section describes how to commission the set in the two available initialization options:
- Static initialization: commissioning is manual on the set and through OMC
- Dynamic initialization (DHCP): no commissioning is needed, 8082 My IC Phone sets are
fully plug & phone
Depending on the selected mode, the set commissioning is different.
For static initialization, the operation order is as follows:
1. Configure the user in OMC, refer to:
2. Connect the set, refer to:
3. Configure network parameters on the set, refer to
static initialization
For dynamic initialization, the operation order is as follows:
1. Configure the DHCP Server, refer to
Figure 4.41: 8082 My IC Phone set connectors
Configuring the user in OMC
Connecting the set
Configuring the DHCP server for dynamic initialization
Configuring network parameters for
4-35