Jumper; Connecting Ap Interface Module; External Connections - Alcatel-Lucent OmniPCX Office Installation Manual

4.8.2.2

Jumper

The jumper in a gray background is factory installed.
To configure the AP Interface Module, open the device with the 2 screws, located under the
module.
If the jumper is positioned for "stand-alone" operation, an associated set cannot work.
If the jumper is positioned for "associated digital set" operation, an associated set is
mandatory, the Interface Module cannot work without it.
4.8.3

External connections

4.8.3.1

Connecting AP Interface Module

The AP Interface Module is connected to:
1. Digital set ( RJ11/RJ11 cable). 3 m maximum length
2. Alcatel-Lucent OmniPCX Office Communication Server via a wall socket and a distributor
Figure 4.57: AP Interface Module Connections
4-73