Connecting Power Supply; Initializing The Sets; Selecting The Initialization Type; Configuring The Dhcp Server For Dynamic Initialization - Alcatel-Lucent OmniPCX Office Installation Manual

Connecting power supply

If not using a PoE switch or the 8082 Power Over Ethernet Injector Kit, connect the AC/DC
external adapter:
1. Plug the appropriate cable from the adapter into the set's power supply connector.
2. Connect the plug from the adapter to the mains power supply.

Initializing the sets

The following paragraphs describe how to:
- Select the initialization type
- Initialize the 8082 My IC Phone set

Selecting the initialization type

The default initialization is dynamic.
To select the initialization type, refer to the following table.
If
You have a DHCP
server
You do not have a
DHCP server

Configuring the DHCP server for dynamic initialization

Two types of dynamic initialization are available:
- Dynamic (default value): the set selects in priority DHCP offers, with a Vendor Specific
option corresponding to an Alcatel-Lucent server.
- Dynamic Alcatel: the set accepts only DHCP offers with a Vendor Specific option
table 4.16: Initialization type selection
Then the required
initialization type is
Dynamic or Proprietary
dynamic
Static
Further information
- Refer to Configuring the DHCP server
for dynamic initialization
- In case of Proprietary dynamic
selection, the IP address of the set must
be provided by the Proprietary router.
- Refer to Configuring network parameters
for static initialization
- Obtain from your network administrator:
• An IP address for the 8082 My IC
Phone set
• The subnetwork mask
• The router address
• The DNS addresses (primary and
secondary)
• The VLAN ID (if VLAN is used)
• The URL of the Alcatel-Lucent
OmniPCX Office Communication
Server for set configuration file
download
Note:
You need to know the set directory number.
4-37