Connecting An Add-On Module To The Sets - Alcatel-Lucent OmniPCX Office Installation Manual

Static 1. Connect the power supply.
2. Before initialization phase 5 starts, press i, then the # key.
3. From the Main menu, choose IP Parameters.
4. Choose Static.
5. Enter the following:
6. Enter the required VLAN details, as follows:
7. Save by pressing the soft key in the upper left part of the display.
8. Exit the Main menu by pressing the soft key in the upper right part of the display.
Note:
If an error message appears during initialization, disconnect the power adapter, then plug it in
again, so that the system restarts initialization.
Restarting initialization
If you want to change a parameter value, restart initialization, as detailed below.
To restart initialization:
1. Disconnect the IP Touch set from the power supply.
2. Reconnect the power supply.
3. Execute the initialization procedure as detailed in
Connecting optional equipment
This section describes how to:
- Connect an Add-On module (AOM) to the sets
- Connect a headset
- Connect an external station speaker

Connecting an Add-On module to the sets

Add-On Modules (AOMs) can be connected to the Alcatel-Lucent IP Touch 4028 Phone,
Alcatel-Lucent IP Touch 4038 Phone and Alcatel-Lucent IP Touch 4068 Phone sets. They are
added to the right side of the set.
Three types of Add-On Module exist and provide keys associated with icons:
- AOM10 provides 10 keys
- AOM40 provides 40 keys
The Main menu appears.
The IP Parameters menu appears.
a. IP address
b. Subnetwork mask
c. Router address
d. TFTP server address
e. TFTP port (69)
f. CPU address
a. If required, select Use VLAN and then enter the VLAN ID number.
b. Ensure that Strict VLAN is set as required. It is selected by default;
de-selecting it allows you to use a DHCP server in another VLAN.
The set restarts from phase 1 with the new parameters.
table: Initialization procedure
4-57