Buderus SB735 Series Installation And Maintenance Manual page 14

6 Boiler Assembly
Hook the rear and central side walls at the bottom
into the edge between the cover and the spacer plate
J NOTICE!
(Fig. 14).
Note the recesses (Fig. 14, Item. 1) in the side
walls:
- Rear side wall 1 recess
(towards the central side wall).
- Central side wall 2 recesses.
- Side wall nearest the front 1 recess (towards
the central side wall).
Lift the side walls and hook the top into edge of the
horizontal brackets (Fig. 15).
Push the side walls back.
Push the ends of the insulation blankets behind the
side wall edge.
Insert the small side sections (Fig. 15, Item. 3) into
the side and at the bottom.
Secure the side wall nearest the front to the central
cross brackets using one self-tapping screw (Fig. 15,
Item. 2) and secure the central cross bracket.
Secure the small side sections (Fig. 15, Item. 3) at
the front using two self-tapping screws each (Fig. 15,
Item.1).
J NOTICE!
Align the side wall position with bolts Fig. 12.
Remove the smaller side sections before
opening the lower reversing door.
We reserve the right to make any changes due to technical modifications!
14
Fig. 14 Hooking in the side walls at the bottom
Fig. 15 Hooking in the side walls at the top
Item. 1: Self-tapping screw for the small side section
Item. 2: Self-tapping screw for the side wall nearest the front
Item. 3: Smaller side section
Buderus Heiztechnik GmbH • http://www.heiztechnik.buderus.de
Boiler Installation and Maintenance Manual SB735 • Issue 10/2003
1
2
1
4