Avaya 4600 Series Administrator's Manual page 47

As of Release 2.6, the 4610SW, 4620SW, 4621SW, and 4622SW IP Telephones support
●
IEEE 802.1X as a Supplicant with the EAP-MD5 authentication method. The modes
supported are as follows:
- Unicast Supplicant operation only with PAE multicast pass-through, with and without
proxy Logoff, and
- Unicast or multicast Supplicant operation without PAE multicast pass-through or proxy
Logoff.
Note:
The 4601 and 4601+ IP Telephones do not support 802.1X as a Supplicant.
Note:
As of Release 2.6, SNMP is disabled by default. You must enable SNMP through DHCP or
●
the 46xxsettings file.
As of Release 2.3, 4600 Series IP Telephones support VLAN separation.
●
As of Release 2.3, 4600 Series H.323 IP Telephones support signaling channel encryption
●
while registering, and when registered, with appropriately administered Avaya Media
Servers.
As of Release 2.0, a 4600 Series IP Telephone's response to SNMP queries is restricted to
●
only IP Addresses on a list you specify.
As of Release 2.0, an SNMP community string is specified for all SNMP messages sent by
●
the telephone.
As of Release 1.8, dialpad access to Local Administration Procedures, such as specifying
●
IP Addresses, is restricted by a password.
Dialpad access to most Local Administration Procedures was removed.
●
The end user's ability to use a telephone Options application to view network data is
●
restricted.
Suggestions for Installation and Configuration
Issue 8 July 2008 47