Avaya 4600 Series Administrator's Manual page 147

Table 15: Viewing Parameter Values (continued)
Name System Value
802.1X pass-thru mode
pass-thru with Logoff
no pass-thru
Supplicant disabled
unicast
uni/multicast
Group nnn
Protocol cccccccc
filename.ext
ccccccc Ethernet
filename.ext
cccccccccc
cccccccccc
Build cccccccccc
DHCPSTD
The View Administration Option
Format
If system parameter DOT1X = 0
If system parameter DOT1X = 1
If system parameter DOT1X = 2
If system parameter DOT1XSTAT = 0
If system parameter DOT1XSTAT = 1
If system parameter DOT1XSTAT = 2
Up to 3 ASCII numeric characters: GROUP.
Note: As of Release 2.8, Communication
Manager Release 3.1.3 and above supports
the downloading of the GROUP settings upon
registration of the individual phone.
Up to 8 ASCII characters, depending on the
system-specific signaling protocol (H.323, SIP,
etc.) currently being used.
Up to 16 ASCII characters: name of the
application code file ("big app") currently stored
in the telephone.
Ethernet connection. From 2 to 7 ASCII
characters, either "100Mbps," "10 Mbps," or
"No."
Up to 16 ASCII characters. Name of the boot
code file ("little app") currently stored in the
telephone.
Up to 10 ASCII characters. DSP code version.
Up to 10 ASCII characters. DSP hardware
version, displayed only if a DSP hardware
version identifier is available.
Build identifier. Up to 10 ASCII characters.
DHCP standard flag. If "1," the telephone strictly
follows the DHCP standard by giving up IP
Addresses when the DHCP lease expires. If "0,"
the telephone uses the IP Address until it
detects reset or a conflict
2 of 3
Issue 8 July 2008 147