Remote Access - AT&T SynJ SB67158 User Manual

Answering system

Remote access

Use this feature to reach your answering system remotely by dialing your
telephone number from any touch-tone telephone.
To remotely reach the answering system:
1. Dial your telephone number from any touch-tone telephone.
2. When the system answers, enter the four-digit remote access code (0000
is the default code; see page 32 to change it).
The system automatically announces the number of messages (new and/or
old) if there are any, and then begins to play them.
3. You can also enter the following remote commands.
Remote commands:
1
3
4
5
6
7
Press to play to all messages.
Press to delete the current message (during playback).
Press to repeat the current message (during playback).
After you hear "Repeat" and within five seconds, press 4 again
to listen to the previous message (during playback).
Press to stop and return to the remote commands (during
playback).
Press to skip to the next message (during playback).
Press to transfer the current message (during playback).
Press to end the call.
79